Motorola AT Commands G24-L Especificações descarregar pdf (Página 11)

2.4 Switch on Java Box Terminal

There are several ways to turn on the Java Box Terminal:

• Switch on via On/Off push button, switch on the Java Box Terminal by pressing the On/Off key

signal line must be asserted for at least 2000 ms and then released.

• Switch on via IGNITION line on the 24pin connector and the 4 pin connector.

Figure 11: On/Off control

2.4.1 Reset Java Box Terminal

An easy way to reset the Java Box Terminal is entering the command AT+CFUN=0,1

2.4.2 Switch Off Java Box Terminal

There are several ways to turn off the java Box Terminal:

• Software controlled shutdown by AT command: AT+MRST

The AT command lets Java Box Terminal log off from the network and allows the software to

enter into a the secure state and safe data before disconnecting the power supply.

The mode is referred to Power-down mode.

• Via On/Off push button.

The Java Box Terminal will be switched off by pressing the On/Off push button or by

activating the On/Off signal for >2s.

• Via IGNITION line.

The Java Box Terminal will be switched off by IGNITION input line connected to GND.

Java Box Terminal Hardware Interface Description

Released

G24

IGNITION

pin 51

On/Off

pin 53

24 pin connector

Pin number 23

Front panel

On/Off switch

Java Box Terminal

4 pin connector

Pin number 2

Pull Up

SW1 – 1 ( IGN )

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Sem comentários

Motorola AT Commands G24-L Especificações Página 11