Motorola T3 Guia do Utilizador descarregar pdf (Página 12)

Motorola, Inc Page 12 of 24

The Motorola WallPlate is designed to be installed over an existing RJ11 wall jack. In cases

where this is not possible; install the WallPlate next to the telephone jack, and route the

telephone cable through the small “mouse hole” in the side.

m2 Ethernet WallPlate MC-802 Wireless WallPlate

1) Install bracket over existing 70mm x 114mm RJ11 wall

jack

Same

2) Install 150mm RJ11 cable between existing RJ11 jack

and bottom mounted RJ11 on WallPlate

Same

3) Snap cover containing circuit board onto the bracket

• Using your finger, pull down the RJ11 cable so that it

doesn’t coil around the crystal on the bottom of the

PCB

• Align the bottom connector first, then with a slight

angle, snap the top connector in place

Attach WallPlate to the plastic

bracket using the provided 8x32

self-tapping screws.

4) If extra security is desired, install 2 set screws into plastic

cover

Pictorial of m2 Ethernet WallPlate Installation

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sem comentários

Motorola T3 Guia do Utilizador Página 12