Motorola MICOM-2TS Especificações descarregar pdf (Página 116)

Installation

Figure 11: Fitting Radio onto Mounting Tray

Step 3.

Use the tie straps included with Cable Kit to tie loose cables out

of the way.

Step 4.

Connect a ground lead from the GND screw on the radio rear

panel to the mobile chassis.

IMPORTANT

Special attention should be given to locating a good

vehicle ground. Optimum radio performance can only

be achieved with a ground connection having a very

low resistance. The vehicle frame makes the best

ground, but body structural reinforcement members

are also suitable for grounding purposes. The ground

lead should be as short as possible.

Step 5.

If desired, plug an external speaker into the accessory

connector. Any speaker with an impedance greater than 8 ohms

can be used.

External Speaker Installation

Connect the external 8 Ohms, 5 Watts speaker to the accessory

connector (pin 1,3). The external speaker is connected in parallel to the

internal speaker.

If disconnection of the internal speaker is required, perform the following

steps:

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 131 132

Sem comentários

Motorola MICOM-2TS Especificações Página 116