Motorola AP-650 Series Guia de Instalação descarregar pdf (Página 17)

AP-650 Series Thin Access Point: Installation Guide

6. Place the large corner of each of the case’s mount slots over the screw heads.

7. Slide the case down along the mounting surface to hang the mount slots on the screw heads.

8. Attach appropriate antennas to the connectors.

9. Attach the Ethernet cable to the unit and to a switch with an 802.3af compatible power source.

10. Verify the unit has power by observing that the LEDs are lit or flashing.

2.7 External Antenna Model Suspended Ceiling Tile (Plenum) Mount

Instructions

Ceiling mount requires placing the AP-650 Thin Access Point above a suspended ceiling and installing

the provided light pipe for viewing the status lights of the unit.

This placement requires installation of the provided light pipe for viewing the status lights of the unit.

2.7.1 Suspended Ceiling Mount Hardware

• Light pipe

• Badge for light pipe

• Safety wire (recommended) and security cable (optional)

NOTE Notes or warnings about suspended ceiling mounts apply to all

installations where the unit is placed on suspended ceiling tile. The case

has a safety wire tie point for a standard safety wire.

CAUTION Motorola does not recommend mounting the AP-650 Thin Access

Point directly to any suspended ceiling tile with a thickness less than

12.7mm (0.5in.) or a suspended ceiling tile with an unsupported span

greater than 660mm (26in.). Motorola strongly recommends fitting the

AP-650 Thin Access Point with a safety wire suitable for the specific

installation. The safety wire should be a standard ceiling suspension

cable or equivalent steel wire between 1.59mm (.062in.) and 2.5mm

(.10in.) in diameter.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Sem comentários

Motorola AP-650 Series Guia de Instalação Página 17