Motorola AP 7161 Guia de Instalação descarregar pdf (Página 58)

58 AP 7161 Access Point

3.1 Antenna Type Configuration

For AP 7161 to operate properly, the antenna type and antenna gain must be configured manually.

Select antenna type with following command:

ap71xx-XXXXXX (config-device-xx-xx-xx-xx-xx-xx-if-radio1)#service antenna-type ap7161-dipole

Select antenna gain with following command:

ap71xx-XXXXXX (config-device-xx-xx-xx-xx-xx-xx-if-radio1)# antenna-gain <units in dBi>

Select VMM antenna type (if available) with following command:

ap71xx-XXXXXX (config-device-xx-xx-xx-xx-xx-xx-if-radio1)# service antenna-type ap7161-vmm

These changes can also be made in the device profile configuration file.

3.2 Automatic Channel Select Override

Under certain conditions (e.g. the presence of a 40 MHz channel intolerant client or a legacy device on the

extension channel), a radio which has been configured for 40 MHz channel operation may automatically select the

20 MHz channel. To override or restore automatic channel selection, use the following commands:

ap71xx-XXXXXX (config-device-xx-xx-xx-xx-xx-xx-if-radio1)#service ignore-ch-width-mgmt

ap71xx-XXXXXX (config-device-xx-xx-xx-xx-xx-xx-if-radio1)#no service ignore-ch-width-mgmt

This change can also be made in the device profile configuration file.

NOTE For FCC and ETSI requirements, set the 2.4GHz antenna gain to 8 dBi and set the 5GHz

antenna gain to 10 dBi.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 79 80

Sem comentários

Motorola AP 7161 Guia de Instalação Página 58