Motorola RSVP RSVP Numeric Display Pager for Micro-TAC Cell Phones Manual do Utilizador descarregar pdf (Página 104)

BRKUCC-2617

105

Access Point Configuration

Use the following guidelines which are outlined in our deployment guides when configuring the access point:

– Set “Quality of Service (QoS)” to “Platinum”.

– Ensure the “WMM Policy” is set to “Allowed” or “Required”

– Ensure “Aironet IE” is enabled

– Ensure that “DTPC” is “Enabled”

– Enable “ClientLink” for 802.11n capable access points

– Enable “Clean Air” for Cisco Aironet 3500 Series access points

– Ensure “Enable Low Latency MAC” is disabled

– Disable “P2P (Peer to Peer) Blocking Action” / “Public Secure Packet Forwarding (PSPF)”

– Disable “DHCP Address Assignment”

– Ensure “MFP Client Protection” is set to disabled or optional

– Ensure “Aggressive Load Balancing” in the Controller configuration or “Client Load Balancing” in the WLAN configuration are disabled

– Enable “Symmetric Mobile Tunnelling Mode” if Layer 3 mobility is being used

– Enable “Short Preamble” if using 2.4 GHz

Note: The WLAN Controller configuration should be validated by using the WLC config analyzer

https://supportforums.cisco.com/docs/DOC-1373

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 120 121

Sem comentários

Motorola RSVP RSVP Numeric Display Pager for Micro-TAC Cell Phones Manual do Utilizador Página 104