Motorola AT Commands G24-L Informações Técnicas descarregar pdf (Página 313)

100

101

Chapter 3: AT Commands Reference

August 5, 2008 AT Commands Reference Manual 3-225

The following table shows the +MIOD parameters.

The following table shows the keypad GPIOs.

Table 3-144: +

MIOD Parameters

<Parameter> Description

<pin selection> Selected pins for the action invoked. This is a binary vector in which each bit points to

pin number. Vector size is 8.

0 Not selected

1 Selected pin (default)

<mode> GPIO pin operation mode.

0 Output (level only)

1 Input (level mode)

<mode vector> This is a binary vector in which each bit shows the operation mode of pin. Data vector

size is 8.

0 Output (level only)

1 Input (level mode)

The default value:

On Power Up - as previously saved in FLEX bytes.

Before set command first used - 1. (This means that all lines are configured as Input

before set command first used).

<data vector> This is a binary vector in which each bit shows the physical value of pin. Data vector

size is 8.

0 Physical low signal.

1 Physical high signal (default).

The default value:

On Power Up - as previously saved in FLEX bytes.

Before set command first used with <Data vector> and <Mode>=0, or after +MIOD

without <Data vector> and before +MIOD command used - 1.

Table 3-145: Keypad GPIOs

GPIO

Name

70 PIN

connector,

PIN#

GPIO

Number

KBC1 28 1

KBC0 30 2

KBR0 32 3

KBR1 34 4

KBR4 36 5

KBR5 38 6

KBR6 40 7

KBR7 42 8

1 2 ... 308 309 310 311 312 313 314 315 316 317 318 ... 679 680

Comentários a estes Manuais

Sem comentários

Motorola AT Commands G24-L Informações Técnicas Página 313

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Motorola AT Commands G24-L