Motorola LD-W-1 Especificações descarregar pdf (Página 5)

Locomotive decoders 30s series English

Page 5

Caution:

Integrated circuits (ICs) are inserted on the decoder. They are sensitive

to static electricity. Do not touch components without first discharging

yourself. Touching a radiator or other grounded metal part will

discharge you.

Checking the package contents

Check the contents of the package for completeness after unpacking:

§ one decoder, with or without soldered connecting wires resp.

soldered NEM or PluX interface connector, depending on the

version,

§ one manual.

N.B. For technical reasons it is possible that the PCB is not completely

inserted. This is not a fault.

Required tools and materials

Make sure you have the following tools and materials ready for use, if

you have purchased a decoder without soldered interface connector:

§ an electronic soldering iron (max. 30 Watt) with a fine tip,

§ a soldering iron stand,

§ a tip-cleaning sponge,

§ a heat-resistant mat,

§ a small side cutter, a wire stripper and a pair of tweezers,

§ tin solder (0,5 mm. diameter),

In order to connect decoders without soldered connecting wires or

connectors you will need wire. Recommended cross sections:

§ > 0,05 mm² for connections to the function outputs

§ > 0,05 mm² for connections to the motor (except for the LD-G-34)

§ > 0,14 mm² for connections to the motor of the locomotive

decoder LD-G-34

1 2 3 4 5 6 7 8 9 10 ... 51 52

Sem comentários

Motorola LD-W-1 Especificações Página 5