Motorola AP-51XX Guia de Instalação descarregar pdf (Página 26)

AP-5131 Access Point: Installation Guide

a. Connect a RJ-45 Ethernet cable between the network data supply (host) and the Power

Injector Data In connector.

b. Connect a RJ-45 Ethernet cable between the Power Injector Data & Power Out

connector and the AP-5131 LAN port.

c. Ensure the cable length from the Ethernet source (host) to the Power Injector and

AP-5131 does not exceed 100 meters (333 ft). The Power Injector has no On/Off power

switch. The Power Injector receives power as soon as AC power is applied. For more

information on using the Power Injector, see “

Power Injector System” on page 8.

For standard power adapter (non Power Injector) and line cord installations:

a. Connect a RJ-45 Ethernet cable between the network data supply (host) and the AP-5131

LAN port.

b. Verify the power adapter is correctly rated according the country of operation.

c. Connect the power supply line cord to the power adapter.

d. Attach the power adapter cable into the power connector on the AP-5131.

e. Attach the power supply line cord to a power supply.

16. Verify the behavior of the AP-5131 LED light pipe. For more information, see

“

LED Indicators” on page 21.

17. Place the ceiling tile back in its frame and verify it is secure.

18. The AP-5131 is ready to configure. For information on basic AP-5131 device configuration,

see “

Configuring “Basic” Device Settings” on page 25.

CAUTION Do not actually connect to the power source until the cabling portion

of the installation is complete.

72-70931_01.book Page 20 Monday, May 4, 2009 8:10 AM

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 49 50

Sem comentários

Motorola AP-51XX Guia de Instalação Página 26