Motorola AP-51XX Guia de Instalação descarregar pdf (Página 34)

AP-5131 Access Point: Installation Guide

b. Specify a Username entered when connecting to the ISP. When the Internet session

begins, the ISP authenticates the username.

c. Specify a Password entered when connecting to the ISP. When the Internet session

starts, the ISP authenticates the password.

7. Click the LAN tab to set a minimum set of parameters to use the AP-5131 LAN interface.

a. Select the Enable LAN Interface checkbox to forward data traffic over the AP-5131

LAN connection. The LAN connection is enabled by default.

b. Use the This Interface drop-down menu to specify how network address information

is defined over the AP-5131’s LAN connection. Select DHCP Client if the larger

corporate network uses DHCP. DHCP is a protocol that includes mechanisms for IP

address allocation and delivery of host-specific configuration parameters from a DHCP

server to a host. Some of these parameters are IP address, network mask, and gateway.

Select DHCP Server to use the AP-5131 as a DHCP server over the LAN connection.

c. Enter the network-assigned IP Address of the AP-5131.

d. The Subnet Mask defines the size of the subnet. The first two sets of numbers specify

the network domain, the next set specifies the subset of hosts within a larger network.

These values help divide a network into subnetworks and simplify routing and data

transmission.

e. Enter a Default Gateway to define the IP address of a router the AP-5131 uses on the

Ethernet as its default gateway.

f. Enter the Primary DNS Server IP address.

g. If using DHCP Server, use the Address Assignment Range parameter to specify a

range of IP address reserved for mapping clients to IP addresses. If a manually (static)

mapped IP address is within the IP address range specified, that IP address could still be

assigned to another client. To avoid this, ensure all statically mapped IP addresses are

outside of the IP address range assigned to the DHCP server.

8. Enable the radio(s) using the Radio Enable checkbox(es). If using a single radio model,

enable the radio, then select either 802.11a (5 GHz) or 802.11b/g (2.4 GHz) from the RF Band

of Operation field. Only one RF band option at a time is permissible in a single-radio model.

If using a dual-radio AP-5131, the user can enable both RF bands.

NOTE For additional AP-5131 WAN and LAN port configuration options, as well

as radio, WLAN and Quality of Service (QoS) options, refer to the

AP-51xx Product Reference Guide.

72-70931_01.book Page 28 Monday, May 4, 2009 8:10 AM

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 49 50

Sem comentários

Motorola AP-51XX Guia de Instalação Página 34