Motorola AP-650 Series Guia de Instalação descarregar pdf (Página 10)

10 AP650 Access Point

3. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall mounting screw and

stop when there is 1mm between the screw head and the wall.

4. If required, install and attach a security cable to the unit’s lock port.

5. Attach the Ethernet cable to the unit and to a controller with an 802.3af-compatible power source.

6. Place the middle of each of the case’s mount slots over the screw heads.

7. Slide the case down along the mounting surface to hang the mount slots on the screw heads.

8. Verify the unit has power by observing that the LEDs are lit or flashing.

NOTE When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.) if

the screws are going directly into the wall and 6mm (0.23in.) if the

provided wall anchors are being used.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Sem comentários

Motorola AP-650 Series Guia de Instalação Página 10