
16 AP650 Access Point
2.9 LED Indicators
Both the Integrated Antenna model and the External Antenna model have LED activity indicators on the front of the
case for use with wall mount. With the External Antenna model unit mounted above a ceiling, LEDs are at the
center of an oval badge on the ceiling; a light pipe enables viewing the back LEDs through the ceiling tile.
The LEDs provide a status display indicating error conditions, transmission, and network activity for the 5 GHz
802.11a/n (amber) radio or the 2.4 GHz 802.11b/g/n (green) radio.
The LED behavior is determined by the version of WiNG software running on the controller which the Access Point
is connected to. The tables below show the LED patterns for WiNG 4.x and WiNG 5.x.
2.9.1 WiNG 4.x LED States
2.9.2 WiNG 5.x LED States
Task 5 GHz Activity LED (Amber) 2.4 GHz Activity LED (Green)
Unadopted Blinking at 5Hz Off
Normal
Operation
If this radio band is enabled:
Blink at 5 second interval
If this radio band is disabled:
Off
If there is activity on this band:
Blink at a 1Hz
If this radio band is enabled:
Blink at 5 second interval
If this radio band is disabled:
Off
If there is activity on this band:
Blink at a 1Hz
Firmware
Update
On Off
Locate AP
Mode
Blink at 5Hz
(Out of Phase with Activity LED)
Blink at 5Hz
(Out of Phase with Activity LED)
Task
5 GHz Activity LED
(Amber)
2.4 GHz Activity LED
(Green)
System Booting
Solid On (During start up
only)
Solid On (During start up
only)
Radio Shutdown Administratively
or
LEDs Disabled
Off Off
Radio Not Configured
or
Country-code not set
or WLAN not mapped to radio
Blink (On 2 seconds, Off 2
seconds)
Blink (On 2 seconds, Off 2
seconds)
Locate AP Mode
Off Blinking
Comentários a estes Manuais