Motorola 7545MBWM Guia do Utilizador descarregar pdf (Página 33)

Basic Operation 1 - 7

Removing the Battery Pack

• If your unit is equipped with a hand strap, unhook it from the base of the battery.

• Press the two buttons at the sides of the compartment simultaneously, and slide the battery out.

Installing the Battery Pack

• Slide the charged battery with the contoured plastic facing you into the unit with the contacts matching

position and the guide tabs moving into the corresponding slots at the base of the compartment. Click both

sides of the battery into place.

• If your computer is equipped with a hand strap, re-attach the clip to the slot at the base of the battery.

• Switch the unit on (see “Switching the Omnii On and Off” on page 1-7).

Switching the Omnii On and Off

Follow the instructions below for your Omnii. If your keyboard has a power button (55- and 66-key keyboards

only), press that instead of the [FN]+[Enter/Power] key combinations described.

Switching the Omnii On

• Press and hold down the [Enter/Power] key for at least one second.

When the unit is turned off, normally it automatically enters a power-saving, “suspend” state. When the Omnii

is switched on from the suspend state, within a few seconds operation resumes in the screen in which you

were working prior to turning the computer off.

Switching the Omnii Off

• To switch off the Omnii, press the [FN] key and then press and release the [Enter/Power] button. The

Omnii will automatically enter the Suspend state.

IMPORTANT If your Omnii fails to power up, consider the following troubleshooting options:

The battery may be overheated (>60C°), a non-Motorola battery may be

installed, or the battery may have fallen below the configured Suspend Thresh-

old. See “Suspend Threshold and Estimated Battery Backup” on page 3-45

for details.

To switch on the hand-held, you will need to replace the overheated battery.

However, if you supply AC power to the Omnii with a battery that falls

below the configured Suspend Threshold, the unit will

switch on.

IMPORTANT Turning off the hand-held does not result in a complete shutdown;

rather, the unit enters a power-saving, “suspend” state. When the

Omnii is turned on from suspend state, operation resumes within a

few seconds.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 305 306

Sem comentários

Motorola 7545MBWM Guia do Utilizador Página 33