Motorola SG 2000 Instruções de Operação descarregar pdf (Página 44)

-8

8 Operation

AT&T SLW2500 Installation and Operation Manual

Cleaning the Optical Connector

The design of the SLW2500 optical module connector enables you to clean it easily without

removing the module from the node.

To clean the connector:

1 If necessary, disconnect the service cable from the module’s optical connector assembly. Place

a dust cover on the service cable connector.

2 Lift the metal tab to release the optical connector assembly and pull it out of the module.

CAUTION!

CACA

CAUTION!

UTION!UTION!

UTION! Do not pull the optical connector out more than two inches from the casting wall. If you pull

the connector out too far, you must disassemble the module and respool the fiber.

3 Remove the bulkhead adapter from the internal optical connector.

4 Carefully clean the optical connector and bulkhead adapter using a suitable optical

connector cleaning kit. If an optical connector cleaning kit is not available, clean the

connector using pure isopropyl alcohol (99%) and a lint-free wipe.

5 Dry it with filtered compressed air. You can also clean the bulkhead adapter using filtered

compressed air.

6 Re-assemble the bulkhead adapter to the internal optical connector. Ensure that you install

the internal optical connector in the end of the bulkhead adapter bearing the metal tangs.

7 Snap the optical connector assembly back into the module.

8 If necessary, clean and reconnect the service cable.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 52 53

Sem comentários

Motorola SG 2000 Instruções de Operação Página 44