Motorola Phaser P460 Especificações Página 29

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 28
2-9
Set Up
Using A Synapse Cable with the cradle
1. Make sure all host devices are powered down.
IMPORTANT
Before power is provided to the cradle (step 6), the following steps must be
completed. The Synapse cable must be connected to the cradle (step 2) AND
the
flying power lead plugged in (step 4). If the cables are not connected in this
sequence, the Synapse Interface Adapter will not operate properly.
2. Connect the Synapse cable to the cradle COM1 port (see Figure 2-3 on page 2-4).
3. Connect the other end of the Synapse cable to the Synapse Interface adapter.
4. The Synapse cable has a flying power lead. Connect this lead to the receptacle in
the Synapse Interface adapter, as shown in Figure 2-8. See the Synapse guide for
details.
Figure 2-8. Synapse and Adapter Cable
5. Connect the Synapse Interface adapter to the host.
6. Connect the power supply to the cradle (see Figure 2-3 and Figure 2-4).
7. Connect the appropriate line cord to the power supply and into an AC receptacle.
8. The indicator light on the cradle blinks, signifying successful power-up.
9. Scan the appropriate Synapse bar codes to set up the Synapse cable for your
specifications.
Synapse Interface
Adapter (Module)
Synapse
Cable
Flying Power
Lead
To Host
To Cradle
Vista de página 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 197 198

Comentários a estes Manuais

Sem comentários