Motorola Phaser P460 Especificações descarregar pdf (Página 71)

5-1

Chapter 5

Parameter Menus

Introduction

This chapter has the optional parameter bar codes necessary to program the Phaser

memory scanner.

Operational Parameters

The Phaser memory scanner is shipped with the settings shown in Table 5-1. These default

values are stored in non-volatile memory and are preserved even when the scanner is

powered down. You can change these default values by scanning the appropriate bar

codes included in this manual. These new values replace the standard default values in

memory. The default parameter values can be recalled by scanning the bar code in the

section Set Default Parameter on page 5-7.

The scanner automatically detects which cable it is attached to, either an RS-232 or a

Synapse cable. If it is attached to an RS-232 cable and has either an ICL, Nixdorf, or Fujitsu

host interface, then scan the appropriate bar code from page 5-11 after power up. Any other

host interface works with the default setting.

If it is attached to a Synapse cable, plug everything together as described on page 2-8 and

then follow the directions that come with the Synapse cable for setting up the host interface.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 197 198

Sem comentários

Motorola Phaser P460 Especificações Página 71