Motorola SG4-DRT-2X Instruções de Operação descarregar pdf (Página 96)

5-6 Installation

SG4000 Installation and Operation Manual

Figure 5-6 illustrates a front and side view of the optional strand bracket mounting

procedure on the SG4000.

Figure 5-6

Optional SG2-style mounting bracket – front and side views

Spacer

blocks

3 Verify that the strand clamps on the mounting bracket are facing the front of the SG4000.

4 Pass the two 5/16 × 18 bolts through the mounting bracket, through the spacer blocks, and

into the same holes that contained the original strand clamp bolts.

5 Tighten the mounting bracket bolts to 10 to 12 ft-lbs.

6 Loosen the two 3/8 × 16 bolts on the strand clamps.

7 Lift the node such that the strand clamps are above the strand.

8 Lower the node until the strand is captured between the clamp halves.

Do not tighten the hex-head bolts at this time. This enables the clamps to slide along the

strand wire until the housing is finally positioned with respect to the cables.

9 Verify that the node is within 10 degrees of hanging straight up and down.

Using the strand bracket mounting assembly slightly impacts the nodes center of gravity.

10 When the housing is in the required position, torque the two strand clamp bolts to

10 to 12 ft-lbs.

11 Re-install any modules and electronic components that were removed before the housing

was installed.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 107 108

Sem comentários

Motorola SG4-DRT-2X Instruções de Operação Página 96